Dillon Quick-Check Wire Tension Meter (Red) Bedienungsanleitung PDF herunterladen (Seite 33)

Quick-Check Red User Instructions 33

7 Troubleshooting

7.1 Quick Check

Problem Possible Cause Solution

Powers on momentarily and turns off Low battery Replace with high quality alkaline batteries

Bad keypad Have unit serviced

Does not power on Low battery Replace with high quality alkaline batteries

Batteries installed

backwards or no spring

contact

Insure that positive terminals of both batteries (nub) face

inward – towards the black cap. Check that spring is attached

to the battery cap.

Software reset Remove battery cap & reinstall after one minute. Attempt to

turn power on again.

Display contrast too

light

Hold the Right Arrow key down while pressing the F2 key

several times to increase the display contrast. If nothing

occurs, release both keys. Press the power button and try

again.

Bad keypad Have unit serviced

Display is completely dark Display contrast too

dark

Hold the Arrow key down while pressing the F1 key several

times to decrease the display contrast.

Display drifts downward once installed Wire material is

creeping and internal

friction between wires

is relieved.

This is normal behavior of wire. Lower display resolution to

mask this effect.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38

Keine Kommentare

Dillon Quick-Check Wire Tension Meter (Red) Bedienungsanleitung Seite 33