FI-80 LCD / FI-80 LED Indicators User’s Manual Contents subject to change without notice. Dillon division of Avery Weigh-Tronix 1000 Arms
F6 Digital Filter Averages load readings to produce higher stability. The higher the filter setting, the greater the stability but the slower the indi
A1 Baud Rate Baud rate for data transmission through the serial port. 1200 2400 4800 9600√ 19200 A2 Data Bits and Parity Number of data b
A11 (LCD version) Peak-Hold Mode Enables “Peak Hold” mode. The display will only increment upward and the peak reading is retained. Press PEAK key t
VIEW CALIBRATION VALUES (F18) 1. While in the Setup mode, scroll to "F 18", then scroll down once using the key to enter View Calibration
Appendix A APPENDIX A: SPECIFICATIONS ANALOG SPECIFICATIONS Excitation Voltage +10 VDC (LED), +5 VDC (LCD) No load input 0.00 mV/V Load cell out
APPENDIX B: SERIAL PORT INFORMATION B.1 SERIAL PORT MODES B.1.1 FULL DUPLEX MODE The Full Duplex Mode provides a Demand serial transmission mode
B.1.1.1 RECOGNIZED HOST COMMANDS “P” - This command is sent to the indicator to print the indicated display. The indicator will not respond if the
B.1.3 SIMPLEX MODE The Simplex Mode provides a continuous serial transmission mode and is selected by setting A3 to “C” and A6 to “0”. The Continuous
APPENDIX C: DISPLAYED ERROR CODES CODE MEANING / POSSIBLE SOLUTION Gross Overload. A load greater than the rated capacity has been applied
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limit
TABLE OF CONTENTS Page Introduction to the FI-80 Series Indicator...
3 INTRODUCTION TO THE FI-80 SERIES DIGITAL INDICATORS The FI-80 Series Digital Indicator is a general purpose, industrial grade force indicator. Two
matches the input voltage marked on the AC adapter. OPERATION D ISPLAY The two display types are 6 digit LCD (Liquid Crystal Display) and 6-digit LE
FRONT PANELS LED version front panel LCD version front panel FUNCTION KEYS PEAK – Toggles the indicator between normal live display mode
3. The FI-80 is not in overload (see Appendix D for error codes). PRINT - Sends display reading through the serial port when the following condition
1. All keys perform as described in the manual while in this mode. Peak-Hold Operation In Peak-Hold mode, the display updates as the load increases
8 SETUP SETUP OVERVIEW The indicator contains two main setup menus: 1. The “F” menu items configure the indicator to the attached load cell and
EXITING THE SETUP MENU 1. Power off the indicator. 2. Move the slide switch on the rear cover back to the left. 3. Power on the indicator. The di
Kommentare zu diesen Handbüchern